clean
After using the hose, clean it. Some hoses used to transport foam must be cleaned carefully to protect the glue layer. In order to remove the grease on the water belt, you can wash it with warm water or soap. For frozen hoses, the first thing to do is to melt them and then clean and dry them. Undried hose should not be rolled up and stored.
layout
When laying the hose, avoid sharp objects and various oils. If you lay the water discharge hose vertically to high places, use hose hooks. When laying water belts through traffic arteries, water belts should be laid down to protect the bridge. When passing the railway, the water belt should pass over the track. Prevent the water belt from being crushed by wheels and causing continuous water supply.
join
When the hose is put on the hose interface, a layer of soft protective material must be placed on it. Then tie it tightly with galvanized iron wire or hose hoop.
use
When using a water hose, the low-pressure resistant water hose should be connected to a location close to the water pump. The water-filled hose should avoid changes or sudden bends. Layflat hose interface should also be prevented from being damaged by collision. And what you need to pay attention to is the hot summer season. When the water supply needs to be suspended on the fire scene, in order to prevent the water belt from freezing, the water pump needs to operate at a slow speed and maintain a small water output.