What are the causes of problems with the hydraulic hose reinforcement?
The biggest advantage of hydraulic hose is that it has a high carrying performance and anti-pressure, then the key to these advantages lies in the steel wire reinforcement layer in the hydraulic hose, that is to say, the steel wire reinforcement layer belongs to the skeleton of the hydraulic hose. Generally our common hydraulic hose is mainly made with wire winding, it is determined by the hydraulic hose carrying capacity. If there is a problem with the reinforcement layer of the hydraulic hose, it can be analyzed and solved according to two points.
1. The hydraulic hose ruptures, causing rusting of the wire that is winded near the hydraulic hose. The problem occurs because the grounded outer glue layer is wet at the production site and then corroded by corrosive material in the factory. This reduces the life of the high-pressure hose and breaks the hydraulic hose when the high pressure is reached. When the hydraulic hose rupture can be the high-pressure hose rupture around the outer rubber peel ingress, you can see the inside of the wire around the rust phenomenon, or the surrounding has been corroded.
2. Hydraulic hose inside the reinforcing layer appears irregular wire break phenomenon, open the outer layer of the high-pressure hose rubber peel found that the reinforcing layer is not rusty, just the emergence of irregular wire, so the reason is mainly that the high-pressure hose has been high frequency of continuous impact. Each well-known customer is aware that the reinforcing layer of the wire and the wire between the intersection, because these wires are woven together, when used the pressure changes from time to time, the intersection will be staggered to produce friction, resulting in wire breakage.
The above about the hydraulic hose reinforcement layer problems, if you have other problems in the hydraulic hose, you can contact us at any time.