The cleaning principle of high pressure cleaning machine is very simple, which is through the high pressure pump or supercharger, through the high pressure pipeline to the nozzle,and then through the high pressure nozzle will be high pressure and low flow rate of water into low pressure and high flow rate of jet. Then use the strong impact of high pressure water jet to impact the object to be cleaned, remove the dirt, so as to achieve the purpose of cleaning.
Because the high-pressure water jet of the high-pressure cleaning machine has the combined crushing effects of scour, wedge splitting, shearing, grinding, etc., it can immediately break off the scale and wash away, so as to realize the separation of the scale layer and the pipe wall. It is much faster than the traditional cleaning method, and it has the coordination of the cleaning hydraulic support, which can get the goal of good cleaning quality, low cleaning cost, high efficiency, no pollution to the environment, high safety, wide application range and so on.
In the high pressure cleaning machine, in addition to cleaning the hydraulic support is very important, the power washer hose pipe should also be paid attention to. If it is properly used and maintained, its use time can be relatively extended to achieve the purpose of saving and reducing costs.
For the power washer hose selected by the high-pressure cleaning machine, its inner diameter must match the caliber required by the high-pressure pump. If the inner diameter of the hose selected and the high-pressure pump are not matched, it will affect the normal use and damage the high-pressure hose prematurely.
And in the selection of power washer hose pipe, in accordance with the technical parameters of the high pressure pump to determine, according to its parameter requirements, choose the rubber hose of the corresponding pressure. Do not use more than the actual pressure under the operation method, otherwise it will affect the normal life of the use of high pressure hose. In addition, the appropriate selection of products under high pressure, so that it is easier to extend its service life.